Bore Polishing Kit

Puff-Lon Fire Lapping Ballistic Filler

Disk shaped polishing compounds of optical quality that smooths the bores surface by fire lapping it with little steel removal. This product can be used to polish your bore as smooth as glass.

Increases:
 Consistency, Accuracy
Decreases: Bore Cleaning, Vibration, Fouling and Friction
Polishes: The Bore evenly from throat to muzzle

Some of the advantages of PUFF-LON fire lapping ballistic filler over other fire lapping procedures:

Continuous polishing throughout the length of the barrel.
Consistent pressure for required reduced loads.
Optical quality dish shaped polishing particles.
An easier procedure to do.


Puff-Lon fire lapping ballistic filler is made with optical disk shaped polishing compounds, which makes it difficult to embed into surface you are trying to polish. The polish is impregnated into a lightweight 100% Pure Cellulose that is compressible and has resiliency. It is granulated so it can be handled with the same ease as your gunpowder and has an infinite shelf-life.

The kit contains four grades of polishing compound:

Coarse: 
Use on new production barrels to smooth out machining marks or 
barrels with erosion or corrosion.

Medium: Use after coarse or on medium smooth barrels.
Fine: Use after medium or on smooth barrels.
Extra Fine: Use after fine or to achieve a mirror finish inside the bore. Use 
Puff-Lon "Lubricating Ballistic Filler" to keep it that way.

CAUTION: All loads should be at least 15% below SAAMI maximum recommendations. Crimp your bullet in place. Do not seat bullet touching forcing cone. Lube all bullets that have lube grooves. Disconnect the gas 
tube on gas-operated automatics if you 
DO NOT wish to polish the piston assembly. For best Accuracy during lapping process, do not use boat tail bullets. Do not use fast burning smokeless powders such as pistol or shotgun powder when near maximum load in rifle cartridges.

DISCLAIMER: Safe reloading practices are the responsibility of the loader. Unsafe reloading may result in serious injury including death and/or damage to personal property. Puff-Lon and it's agents, distributors and assigns assume no responsibility for injury or damage resulting from the improper use of this product.

Thank you for purchasing Puff-Lon fire lapping ballistic filler kit. Lapping by firing cartridges that have abrasive fillers is a new concept. Every gun will benefit from bore lapping. Cleaning will be easier and accuracy will be improved. The bore lapping process removes only a small amount of steel, therefore it will not remove deep pits but does smooth the edges of them.

Bore Polishing Kit for Firearms $55.95

Qty:
Share Product
Share via E-Mail
Share on Facebook Share on Twitter